Table of Contents
Advertisement
JOINING KIT INS TALL ATION
Kit Sizes: 60" (1524 mm) / 72" (1828.8 mm) / 78" (1981.2 mm) / 90" (2286 mm)
K I T C ON T EN T S
• (1) Joining Rainshield Assembly
• (1) Joining Kickplate
• Anti-Sweat Foam End Panels*
• Joining Bracket*
• 1/4-20 x 1" Hex Head Screws*
• 1/4" Split Lock Washers*
*Quantities vary by kit size.
R EQUIR ED T O O L S
Required tools include (but may not be limited to) the
WARNING: To avoid a hazard due to instability of
the appliance, it must be fixed in accordance with
following:
the instructions.
• Phillips Bit Driver or Screwdriver
AVERTISSEMENT: Pour éviter tout risque dú a
l´instabilité del l´appareil, vous devez le fixer
• 7/16" Socket Wrench
conformément aux instructions.
• 1/4" Socket Wrench
• Tape
• Marking Utensil
• Drill
C AU T ION!
hazard. Unplug the unit or turn off the
power supply before proceeding.
WA R NING! T IP O V ER H A Z A R D.
To avoid hazards from appliance
instability, be sure to install the anti-tip
brackets (see fig. 1) on each individual
unit per the installation manual instructions.
P R O CEDUR E
1. Remove the reed switch bracket. See figs. 2 and 3.
2. Remove the reed switch cover, and then
disconnect the reed switch. See figs. 4 and 5.
Page 26 of 56
T RU E R E S I D E N T I A L
I N S T A L L A T I O N
R
9 9/32"
236mm
Electrical shock or burn
22 31/32"
583mm
PROUD INSTALL
®
WA R NING! T IP O V ER H A Z A R D.
A child or adult could tip the appliance,
resulting in property damage or bodily
harm. Follow these instructions to
properly install the anti-tip device. If the appliance
is moved, verify that the device is properly engaged
before the normal usage of the appliance commences.
FIG. 1.
Anti-tip bracket. Be sure to install a bracket for each unit.
C L
C L
FIG. 2.
Pull the rainshield open.
FIG. 3.
Locate the reed switch in the bottom of the rainshield.
FIG. 4.
Remove the plastic cover.
P# 82 91 0 2
10/30/2023
TR-30REF-R-SG-A
9 9/32"
236mm
24 31/32"
634mm
FLUSH INSTALL
TEC_TM_151 | REV. E | EN
Advertisement
Table of Contents
