Table of Contents
Advertisement
REFRIG ER ATOR S TOR AG E
The refrigerator section of the cabinet is divided into
shelving and produce / crisper bins.
SHELV ING
The shelving comes installed on the unit. See figs. 1
and 2. It is adjustable for customer application.
SH ELVING ADJUSTM ENT
1. Gently lift the front of the shelf and unhook the
shelf from the shelf standards on the back wall.
See fig. 3.
2. Hook the shelf into the pilaster at the desired
height.
D O O R BIN S (SO L ID D O O R S ONLY )
Door bins are only available for solid door units.
1. Locate the door bins packaged in the top
refrigerator drawer. See fig. 4.
2. Hook the door into the door slots at the desired
height. See fig. 5.
3. Push the door bins down to ensure the tabs are
fully engaged in the slots. See fig. 6.
P R O DUCE / CR I SP ER BIN S
The refrigerator section has three drawers. See the
instructions below for drawer removal or reinstallation.
BIN REMOVAL
1. Fully open the drawer.
2. With a Phillips screwdriver, remove the drawer slide
screws. See fig. 7.
3. Lift the drawer from the unit.
BIN INSTALLATION
1. Pull the drawer slides fully forward.
2. Slide the drawer into position until the drawer rests
under the rear hooks on the drawer slides.
3. With a Phillips screwdriver, fasten the drawer to the
drawer slides.
TEC_TM_151 | REV. E | EN
C A B I N E T S E T U P
FIG. 1.
Remove the interior
packaging holding the shelving
in place.
FIG. 3.
Unhook the shelves from the
shelf standards to adjust the shelving.
FIG. 4.
Door bins packaged in the
top refrigerator drawer.
FIG. 6.
Be sure the door bins are
fully seated.
10/30/2023
FIG. 2.
Installed cabinet shelving.
FIG. 5.
Hook the door bin into
the door.
FIG. 7.
Drawer slide screw
locations. Top drawer shown.
T R- 3 6 RB F I N S TA L L G U I D E
Page 33 of 56
Advertisement
Table of Contents
