Table of Contents
Advertisement
ELEC TRIC AL SAFE T Y
Power Supply: 115VAC, 60hz
Circuit Breaker: 15 Amp
Receptacle: 3-Prong Grounding-Type
• For all built-in models, the electrical supply should
be located within the indicated shaded area shown
in the figure below.
• Be sure to follow the National Electrical Code, as
well as local codes and ordinances, when installing
the receptacle.
• A ground fault circuit interrupter (GFCI) is not
recommended and may cause interruption of
operation.
• The power cord from this appliance is equipped
with a grounding plug which minimizes the
possibility of electric shock hazard.
• The wall outlet and circuit should be checked by a
licensed electrician to be sure the outlet is wired
with the correct polarity and properly grounded.
• If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with a properly grounded wall outlet.
D O NO T
•
, under any circumstances, cut or remove
the ground prong from the power cord. For personal
safety, this appliance must be properly grounded.
• The refrigerator/freezer should always be plugged
into a dedicated electrical circuit. This provides
the best performance and prevents building wiring
circuits from overloaded, which could cause a fire
hazard from overheated wires.
NE V ER U SE A N A DA P T ER P L UG!
•
An adapter plug alters the original
equipment manufacturer (OEM)
plug configuration when connecting
it to a power source. True will not warranty any
refrigerator/freezer that has been connected to an
adapter plug.
NE V ER U SE A N E X T EN SION
•
C O R D!
An extension cord is any
component that adds length to the
OEM power cord when connecting
TEC_TM_151 | REV. E | EN
S I T E P R E P A R A T I O N
it to a power source. True will not warranty any
refrigerator/freezer that has been connected to an
extension cord.
• Before your new unit is connected to a power
supply, check the incoming voltage. If the recorded
voltage is less than the rated voltage for operation
(+/-5%) and amp rating, correct immediately. Refer
to the serial label for this voltage requirement.
NE V ER
•
on the power cord. Always grip the plug firmly and
pull straight from the outlet.
• When moving the refrigerator/freezer for any reason,
take care to no roll over or damage the power cord.
• Immediately repair or replace all power cords
that have become frayed or otherwise damaged.
D O NO T
abrasion damage along its length or at either end.
• If the supply power cord is damaged, replace it
with OEM components. To avoid hazard, this should
be done by a licensed service provider or similarly
qualified person.
NOTE: DIMENSIONS MAY VARY BY ± 1/8" (3.175 mm)
10/30/2023
unplug your refrigerator/freezer by pulling
use a power cord that shows cracks or
ELECTRICAL AREA
T R- 3 6 RB F I N S TA L L G U I D E
Page 13 of 56
Advertisement
Table of Contents
