Table of Contents
Advertisement
JOINING KIT INS TALL ATION (CONT.)
Kit Sizes: 60" (1524 mm) / 72" (1828.8 mm) / 78" (1981.2 mm) / 90" (2286 mm)
14. Walk the joined units into their final installation
location.
15. Verify the level of the cabinets. Level the units as
needed.
16. Restore power to the units and turn the units on.
17. After 3 minutes of runtime, open the doors
individually and verify correct door switch
operation. When operating correctly, the following
should occur:
• Unless set otherwise, the lights turn on and off
with the door openings.
• The evaporator (interior) fan turns on and off
with door openings.
• There is a low-pitched click from the control
board area when the door opens or shuts.
18. Install the joining kit grill.
FIG. 17.
Return the magnet bracket screws to their original locations
FIG. 19.
Installed joining rainshield.
TEC_TM_151 | REV. E | EN
I N S T A L L A T I O N
FIG. 15.
Verify the cabinet fronts are flush. Adjust the units
accordingly.
FIG. 16.
Verify the gap(s) between cabinets is (are) even throughout.
FIG. 18.
Installed joining bracket.
FIG. 20.
Connect the reed switches with the original wire configurations.
10/30/2023
1
2
T R- 3 6 RB F I N S TA L L G U I D E
3
4
Page 29 of 56
Advertisement
Table of Contents
