Configuring Audio Routes With The Dante Controller - Shure ULX-D Quad Manual

Optionally, the Shure Control Device ID can be entered from the receiver front panel:
1. From the receiver menu: DEVICE UTILITIES > NETWORK > SHURE CONTROL > Dev. ID
2. Use the control wheel to edit the ID.
3. Press ENTER to save.
Creating a Dante Device ID
There are two ways to create a Dante ID:
1. Enter the ID using the receiver menu.
2. Enter the ID using a keyboard from the Dante controller.
If entering IDs from the receiver menu, additional ID modes are available for quickly adding sequential numbering to multiple
receivers or adding a prefixes for network discovery by Dante enabled Yamaha mixing consoles.
Note: Changing the Dante ID will cause a loss of audio signal. After an ID has been changed, use the Dante controller to restore audio route subscriptions us­
ing the new ID.
Setting the Device ID from the receiver menu:
DEVICE UTILITIES > NETWORK > DANTE > Dev. ID
1.
2. Use the control wheel to select an ID MODE:
◦ Off: Manually enter an ID by using the control wheel. Press ENTER to save.
◦ Sequential: Adds a 3-digit numerical prefix to the receiver model name to create the device ID. (ex: 001-Shure-
ULXD). Use the control wheel to increment the prefix value. Press ENTER to save.
◦ Yamaha: Adds a prefix starting with "Y" followed by 3-digits to the receiver model name to create a device ID that
allows Dante enabled Yamaha mixing consoles to discover ULX-D receivers on a Dante network. (ex: Y001-Shure-
ULXD). Use the control wheel to increment the prefix numerical value. Press ENTER to save.
Entering the Device ID from the Dante controller:
1. Open the Device View and select the receiver from the pulldown menu.
2. Click on the Device Config tab.
3. Enter the ID in the Rename Device box and press ENTER.
Viewing Dante Device IDs in the Dante Controller
Dante device IDs are displayed in the Network View window in the Dante Controller.
1. Launch the Dante controller and open the Network View window.
2. Verify that the Dante device IDs match the IDs entered in the receiver.
Identify Device Feature
The Dante controller's Identify Device feature flashes the front panel LEDs of a selected receiver to provide identification when
multiple receivers are in use.
Open the Device View in the Dante controller and click on the identify icon (eye). The front panel LEDs of the selected receiver
will respond by flashing.

Configuring Audio Routes with the Dante Controller

Devices that appear in the Dante controller are categorized as "Transmitters" and "Receivers"
In order for audio to flow in the network, audio routes (subscriptions) must be configured between transmitters and receivers.
Note: ULX-D receivers will appear in the Dante controller as a Transmitter. Devices that have both inputs and outputs commonly appear as both transmitters
and receivers.
Shure Incorporated
44/70