Assigning Network Device Ids For Shure Control And Dante Control - Shure ULX-D Quad Manual

Assigning Network Device IDs for Shure Control and Dante Control

When using the receiver in a network with Shure Control (WWB6) and a Dante Controller, two Device IDs are required: one for
Shure Control and one for Dante Control. Device IDs are used to identify devices on the network and for creating Dante digital
audio routes.
Best Practices
Using the following best practices will help to organize network setup and ease troubleshooting.
• For consistency, convenience, and easy troubleshooting, use the same device ID for both WWB6 (Shure Control) and for
the Dante network.
• The Dante network requires unique Dante device IDs to prevent a loss of audio signal routing. Any duplicate IDs on the
network will be tagged with a number such as -1, -2, -3, etc.... and must be changed to a unique value.
• WWB6 (Shure Control) does not require unique device IDs and duplicates do not affect the Dante network; however, a
best practice is to use unique device IDs.
Setting the Shure Control Device ID
1. Launch WWB6.
2. Open the Inventory View.
3. Click on the Device ID to enable editing.
Tip: Click on the device icon next to the channel name to identify the receiver using the Flash function.
Shure Incorporated
43/70