Configuring Audio Routes With The Dante Controller - Shure ULX-D User Manual

Configuring Audio Routes with the Dante Controller

Devices that appear in the Dante controller are categorized as "Transmitters" and "Receivers"
In order for audio to flow in the network, audio routes (subscriptions) must be configured between transmitters and receivers.
Note: ULX-D receivers will appear in the Dante controller as a Transmitter. Devices that have both inputs and outputs commonly appear as both transmitters and receivers.
Dante Transmitters
Devices that send or add audio into the network such as:
• Receiver Outputs
• Amplifier Outputs
• Mixer Outputs
• Signal Processor Outputs
• Recorder Playback Outputs
Forming an Audio Route
Launch the Dante Controller and click on the intersection point between components to form an audio route. The audio route is also referred to as a
Subscription.
1. Find the intersection between the transmitter and receiver channels.
2. Click on the where the components meet.
+
3. A green checkmark indicates that the audio route has been established.

4. Check the audio to verify that the audio route has been formed.
For additional information about the Dante controller, visit www.audinate.com.
Enter text to show only those
Dante devices and channels
containing that text
Click to expand all Dante
devices and view all Rx
channels
Click to collapse the Dante
device Rx channel view
Click to expand all Dante device
and view all Tx channels
Dante Receivers
Devices that receive audio from the network such as:
• Amplifier Inputs
• Mixer Inputs
• Signal Processor Inputs
• Recorder Inputs
Click to expand this Dante device
to view its Tx channels
Click while holding the Ctrl
key to subscribe to all possible
channels at the same time.
21