Creating A System Preset; Batteries - Shure ULX-D Quad Manual

Feature
LOCK
RF POWER
BATT
BP OFFSET
HH OFFSET
MUTE MODE
Cust. Group
Note: When Cust. Groups is set to on, it may take up to 30 seconds to complete an IR sync.

Creating a System Preset

System Presets allow a current receiver setup to be saved and restored. Presets store all receiver settings to provide a quick
way to configure a receiver or switch between several different setups. Up to 4 presets can be stored in receiver memory.
To save the current receiver setup as a new preset: DEVICE UTILITIES > SYSTEM RESET > SAVE > CREATE NEW PRESET
Use the control wheel to name the preset, and then press Enter to save.
To recall a saved preset: DEVICE UTILITIES > SYSTEM RESET > RESTORE
Use the control wheel to select the preset name, and then press Enter.

Batteries

The transmitter runs on two AA batteries or the Shure SB900 rechargeable battery. Use the included AA battery adapter when
using batteries other than the Shure SB900.
Bodypack: Remove the adapter when using the Shure SB900
Handheld: Rotate and store the adapter in battery door when using Shure SB900
Setting
Power, Menu, All, None
10mW=Nm (normal), 1mW=Lo (low), 20mW=Hi (high)
Alkaline, NiMH, Lithium
0 dB to +21 dB (in 3 dB increments)
0 dB to +21 dB (in 3 dB increments)
OFF, ON
OFF, ON
Shure Incorporated
24/70