Planet IPOE-17 S Series User Manual page 12

Step 4: Install the terminal block on PLANET IPOE-17xS Series Splitter.
Step 5: Connect the network copper cable (RJ45) from an 802.3bt PoE++
PSE to the IPOE-17xS Series Splitter where the power and data are
separately transmitted to a PD as shown in the figure below (The
following figure is based on the IPOE-173S. The display of the other
IPOE-17xS Series is the same):
802.3bt PoE++
PSE
Make
12V/19V/24V) is correct before applying power to a remote
device.
12
802.3bt PoE++ Data in
10/100/1000T Copper
sure the IPOE-17xS
Non-PoE
Data Out
DC-
DC+
Series' output
Device
voltage (DC