Data Collection Problems; Data Collection Problems - Neuropace 5106 Manual

Data Collection Problems

DaTa CoLLECTIoN PRoBLEMS

Problems Getting Data
One of the following messages appears on the screen:
• "Unable to communicate with the neurostimulator. Reposition the wand
over the Neurostimulator."
Problem
• "Telemetry has been lost. The Wand may have been unexpectedly or
temporarily disconnected. Unplug the Wand's USB cable and re-attach
it to recover from this error."
• The wand was moved while collecting data from the neurostimulator.
Possible
• The wand cord may be loosely connected or disconnected from the
Causes
tablet USB port.
• There is interference from a nearby electronic device.
What to • Follow the on-screen
Do instructions.
• Use the signal strength bar
on the screen to help you
position the wand over the
neurostimulator to maximize
signal strength. The cupped side
of the wand should be facing the
neurostimulator. Data collection
should continue when the signal
strength is high.
• Make sure the wand is properly
connected to the tablet.
• If the signal quality is low, a nearby
electronic device (e.g., another
computer, television, microwave, etc.)
may be causing interference, or there
may be interference if the remote
monitor power cord is plugged into an
electrical outlet. If it is plugged in, make
sure the battery is charged adequately
and then disconnect from power. If this
does not solve the problem, try moving
the remote monitor to another location
and then try again to get data and
observe the wand signal.
45