Table of Contents
Advertisement
Setup the Remote Monitor
FIND a GooD PLaCE To SETUP
The remote monitor is intended to be used by the patient at home. Follow the steps below
to set up the remote monitor for use. Contact NeuroPace Customer Support if you need
assistance to set it up or to report any unexpected events.
Safety Information on page 4
Review the
Find a suitable place to set up the remote monitor. This should be an area:
•
Away from water, moisture or dampness that
can damage the wand and tablet.
•
Away from extreme temperatures (below
32°F or above 95°F) that can interfere with
wand and tablet operation.
•
Away from small children and pets who can
damage the wand and tablet.
•
Away from large electrical appliances that
might be a source of electromagnetic
interference (EMI) and interfere with wand
and tablet operation.
CHaRGE THE REMoTE MoNIToR
1
Locate the power connection on your
tablet. Plug one end of the power cord
into the tablet and the other end into
an electrical outlet. You may need an
outlet that accepts a 3-pronged plug. If
your power cord comes as 2 separate
pieces, first attach the 2 pieces before
connecting the tablet to the outlet.
before continuing.
•
Near an electrical outlet that will accept the
type of power cord plug that came with your
tablet.
•
In range of your Wi-Fi network.
You will not be able to confirm that there are no
large sources of EMI nearby until you observe
the wand signal while collecting data.
Refer to
Get Data from Your Neurostimulator
on page
27.
1
2
2
Locate the USB port on your tablet. Plug
the wand cord into the USB port. The
image below shows the remote monitor
tablet with all connections made while
charging.
The tablet computer you
receive may not be the same
model shown here. The
location of the connections
may also differ from the
model shown here.
17
Advertisement
Table of Contents
