Turn On The Remote Monitor - Neuropace 5106 Manual

Turn on the Remote Monitor

Note: Before turning on the remote monitor, be sure you have completed the section
Remote Monitor on page
battery will not be fully charged until it is plugged into the outlet for about two hours.
1
Press the power switch near the upper corner.
When you power on the tablet, the remote monitor first checks for any software updates to
install. If the remote monitor has a software update ready to install, the NeuroPace Update
Center appears before you get to the Home screen. NeuroPace recommends you install
all software updates right away, and it usually takes only a matter of minutes to install. For
instructions, refer to
Note: If the tablet does not turn on, it may not be connected to an electrical outlet, or the
tablet battery may be drained.
17. If this is the first time you are using the remote monitor, the tablet
1
NeuroPace Update Center on page
Setup the
35.
19