Nikon D2X User Manual page 219

Custom Setting f4: Assign FUNC. Button
This option controls the function performed by
the FUNC. button. Highlight f4 FUNC. Button in
the second level of the CSM menu (
press the multi selector to the right. Press the
multi selector up or down to highlight an option,
then press to the right to make a selection.
Option
FV Lock If SB-800 or SB-600 Speedlight is attached, fl ash value locks when
(default) FUNC. button is pressed. Press again to cancel FV lock.
As above, except that when SB-800 or SB-600 is off or not attached,
FV Lock/
FUNC. button and command dials can be used to specify focal length
Lens data
and aperture of non-CPU lenses (
If FUNC. button is pressed when rotating command dials, changes to
1 step
shutter speed (exposure modes S and M) and aperture (exposure modes
spd/
A and M) are made in increments of 1 EV.
aperture
Same as
AE-L/AF-L FUNC. button performs same functions as AE-L/AF-L button.
Flash off Flash will not fi re in photos taken while FUNC. button is pressed.
While FUNC. button is pressed, all shots in exposure or fl ash bracketing
program will be taken each time shutter-release button is pressed. In
continuous high-speed and continuous low-speed modes, camera will
Bracket-
repeat bracketing burst while shutter-release button is held down. If
ing burst
white-balance bracketing is selected, camera will take photos at up to
8 fps (single or continuous high-speed mode) or 1–7 fps (continuous low-
speed mode) and perform white balance bracketing on each frame.
Matrix
metering Matrix metering activated while FUNC. button is pressed.
Center-
weighted Center-weighted metering activated while FUNC. button is pressed.
Spot
metering Spot metering activated while FUNC. button is pressed.
FUNC. button and main command dial can be used to turn high-speed
Hi-speed
crop mode on and off (
Crop
after fi rst shot in multiple exposure.
178) and
Description
128).
41). Hi-speed crop mode can not be changed
205