Digi IX20 User Manual page 457

Routing
9. (Optional) For Password, type a password that will be used to authenticate this VRRP router
with VRRP peers. If the password length exceeds 8 characters, it will be truncated to 8
characters.
10. Configure the virtual IP addresses associated with this VRRP instance:
a. Click to expand Virtual IP addresses.
b. Click  to add a virtual IP address.
c. For Virtual IP, type the IPv4 or IPv6 address for a virtual IP of this VRRP instance.
d. (Optional) Repeat to add additional virtual IPs.
11. See Configure VRRP+
12. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a VRRP instance. For example:
(config)> add network vrrp VRRP_test
(config network vrrp VRRP_test)>
4. Enable the VRRP instance:
(config network vrrp VRRP_test)> enable true
(config network vrrp VRRP_test)>
5. Set the interface on which this VRRP instance should run:
a. Use the ? to determine available interfaces:
(config network vrrp VRRP_test)> interface ?
Interface: The network interface to communicate with VRRP peers on and
listen for traffic to virtual IP addresses.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
IX20 User Guide
for information about configuring VRRP+.
Virtual Router Redundancy Protocol (VRRP)
457