Digi IX20 User Manual page 367

Enable hotspot using the default configuration
The default configuration of the IX20 device's hotspot is:
Hotspot
Bridge
Access points
LAN
To use the default hotspot with click-through authentication, enable the hotspot, the bridge, the
access points, and the LAN.
In additional to enabling the default hotspot configuration, you may also want to:
n Change the default hotspot
n Change the default authentication method:
Configure the hotspot to use local shared password
l
Configure the hotspot to use RADIUS shared password
l
IX20 User Guide
Default configuration
n Name: hotspot
n Disabled
n Authentication mode: Click-through
IP address: 10.1.0.1/24
n
DHCP server: Automatically enabled
n
DHCP server lease range: 100-250
n
n Bandwidth limits:
Maximum download speed: 10000 Kbps
l
Maximum upload speed: 10000 Kbps
l
n Name: hotspot_bridge
n Disabled
n 2.4 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
Fi)
Name: Digi Hotspot AP (Wi-Fi)
n
n Disabled
n SSID: Digi Hotspot
n Encryption: Open (unencrypted)
Hotspot access points should be set to open
n
(unencrypted). See
information.
n Name: LAN hotspot
n Disabled
n Device: hotspot_bridge
IP address: 192.168.100.1/30
n
This IP address is not used by the hotspot or the
hotspot's DHCP server. It must be a unique IP
address that is not used elsewhere in your
network.
DHCP server: Disabled
n
n The hotspot will use the hotspot's DHCP server
rather than the LAN's DHCP server.
SSID.
Hotspot security for further
authentication.
authentication.
Hotspot
367