Digi IX20 User Manual page 102

Interfaces
n
n
n
IX20 User Guide
modem_power_cycle: This recovery action is available for WWAN interfaces only.
If modem_power_cycle is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
reboot_device.
If reboot_device is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
custom_action: Execute custom recovery commands.
If custom_action is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the commands to run to attempt to recovery connectivity.
l
Wide Area Networks (WANs)
102