Electrolux EKC603601X User Manual page 19

• Do not move the appliance by hand after
removed the packaging. Do not use a
sack barrow or any other aid to lift the
appliance. It can cause a damage.
• To move the appliance, open the oven
door and lift the appliance by holding in-
side the top of the component.
• You can fit your freestanding appliance
with cabinets on one or both sides and in
the corner.
• Protect sidewalls above the hob level by
heat resistant noncombustible material
and provide minimum 40 mm distance
from the sidewalls to the hob side.
• Provide minimum 2 mm air gap at either
side of the appliance to enable moving it
into position.
• Surfaces above the hob (also cooker
hoods) must be a minimum of 685 mm
above the hob.
The anti-tilt protection
Caution! You must install the anti-tilt
protection (A+B). If you do not install it
the appliance can tilt.
Before you install anti-tilt protection,
adjust the appliance to the correct
height.
The anti-tilt protection has two parts (A+B).
You can find the anti-tilt protection (B) on
right or left side of the rear wall of the appli-
ance (See fig. 1). You must install the anti-
tilt protection (A) on the wall. The distance
of the hole of the anti-tilt protection (A) from
the floor is about 816 mm. Make sure you
install the anti-tilt protection (A) at the cor-
rect height. Screw it into the solid material
or use applicable reinforcement.
Check that the anti-tilt protection projects
minimum 20 mm into the hole in the back
of the appliance (B) when you push the ap-
pliance (See fig. 2). If the space between
the bench cupboards is greater than the
width of the appliance, you must adjust the
side measurement to centre the appliance.
Make sure that the surface behind the ap-
pliance is smooth.
1
2
Electrical installation
Warning! Only a qualified and
competent person must do the
electrical installation.
The manufacturer is not responsible if
you do not follow safety precautions
from chapter "Safety".
This appliance is supplied without a main
plug and a main cable.
Covering terminal board
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover,
make sure that the lower tabs are located
inside the bottom edge of the aperture, be-
fore you fix the two screws into the top
edge of the mains terminal cover.
Make sure that the cover is securely fas-
tened.
To open the cover of terminal board
obey the procedure in opposite se-
quence.
electrolux 19
60 mm
50 mm
A
B