Clutch Lever - Yamaha Star 2010 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
4
while you are stopped at an intersec-
tion.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
"SELECT" switch "
This switch is used to perform selec-
EAU12500
tions in the odometer and tripmeters, to
set the clock and to set the brightness
control mode of the multi-function
EAU12660
meter unit.
/ "
See "Multi-function meter unit" on page
" before starting
4-4 for detailed information.
" to
"RESET" switch
This switch is used to reset the tripme-
ters, to set the clock and to set the
brightness control mode of the multi-
function meter unit.
See "Multi-function meter unit" on page
4-4 for detailed information.
EAU12711
"

Clutch lever

EAU41700
1. Clutch lever
EAU42524
/ " The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
EAU42535 tion circuit cut-off system. (See page
4-17.)
4-8
EAU12820