HIKVISION iDS-9000HQHI-M8/S Series User Manual page 9

Before connecting and operating your device, please be advised of the following tips:
The device is designed for indoor use only. Install it in a well-ventilated, dust-free environment
●
without liquids.
Ensure recorder is properly secured to a rack or shelf. Major shocks or jolts to the recorder as a
●
result of dropping it may cause damage to the sensitive electronics within the recorder.
The device shall not be exposed to water dripping or splashing, and no objects filled with liquids,
●
such as vases, shall be placed on the device.
No naked flame sources, such as lighted candles, should be placed on the device.
●
The ventilation should not be impeded by covering the ventilation openings with items, such as
●
newspapers, table-cloths, curtains, etc. The openings shall never be blocked by placing the
equipment on a bed, sofa, rug or other similar surface.
For certain models, ensure correct wiring of the terminals for connection to an AC mains supply.
●
For certain models, the equipment has been designed, when required, modified for connection
●
to an IT power distribution system.
identifies the battery holder itself and identifies the positioning of the cell(s) inside the
●
battery holder.
+ identifies the positive terminal(s) of equipment which is used with, or generates direct current.
●
- identifies the negative terminal(s) of equipment which is used with, or generates direct current.
Keep a minimum 200 mm (7.87 inch) distance around the equipment for sufficient ventilation.
●
For certain models, ensure correct wiring of the terminals for connection to an AC mains supply.
●
Do not touch the sharp edges or corners.
●
When the device is running above 45 °C (113 °F), or its HDD temperature in S.M.A.R.T. exceeds
●
the stated value, please ensure the device is running in a cool environment, or replace HDD(s) to
make the HDD temperature in S.M.A.R.T. below the stated value.
Provide a surge suppressor at the inlet opening of the device under special conditions such as
●
the mountain top, iron tower, and forest.
Do not touch the bare components (such as the metal contacts of the inlets) and wait for at least
●
5 minutes, since electricity may still exist after the device is powered off.
The USB port of the equipment is used for connecting to a mouse, keyboard, USB flash drive, or
●
Wi-Fi dongle only. The current for the connected device shall be not more than 0.1 A.
The serial port of the device is used for debugging only.
●
If the power output port of the device does not comply with Limited Power Source, the
●
connected device powered by this port shall be equipped with a fire enclosure.
If a power adapter is provided in the device package, use the provided adapter only.
●
For the device with sticker
●
parts! Do not touch. Burned fingers when handling the parts. Wait one-half hour after switching
off before handling the parts.
If the device needs to be installed on the wall or ceiling,
●
Digital Video Recorder User Manual
Preventive and Cautionary Tips
or , pay attention to the following cautions: CAUTION: Hot
viii