HIKVISION iDS-9000HQHI-M8/S Series User Manual page 10

1. Install the device according to the instructions in this manual.
2. To prevent injury, this device must be securely attached to the installation surface in
accordance with the installation instructions.
Under high working temperature (40 °C (104 °F) to 55 °C (131 °F)), the power of some power
●
adapters may decrease.
Make sure that the power has been disconnected before you wire, install, or disassemble the
●
device.
If the device needs to be wired by yourself, select the corresponding wire to supply power
●
according to the electric parameters labeled on the device. Strip off wire with a standard wire
stripper at corresponding position. To avoid serious consequences, the length of stripped wire
shall be appropriate, and conductors shall not be exposed.
If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
●
power cable, and contact the service center.
Coin/Button Cell Battery Replacement
The coin/button cell battery should be replaced when the device has been powered off or placed
for a long time, and the system time is incorrect.
Before You Start
Power off your device.
Steps
1. Remove the device chassis cover.
2. Find the coin/button cell battery on motherboard.
3. Use tweezers to push the metal latch at the middle from its inside, and the battery would
automatically pop up.
4. Take out the old battery and press a new battery with the same model in to the battery slot.
Digital Video Recorder User Manual
Figure 1-1 Remove Battery
ix