Table of Contents
Advertisement
5. Click Apply to save the settings.
6.4 Configure Linkage Actions
Alarm linkage actions will be activated when an alarm or exception occurs.
6.4.1 Configure Auto-Switch Full Screen Monitoring
When an alarm is triggered, the local monitor displays in full screen the video image from the
alarming channel configured for full screen monitoring. And when the alarm is triggered
simultaneously in several channels, you must configure the auto-switch dwell time.
Note
Auto-switch will terminate once the alarm stops and back to the live view interface.
Steps
1. Go to System → Live View → General .
2. Set the event output and dwell time.
Event Output
Select the output to show the event video.
Full Screen Monitoring Dwell Time
Set the time in seconds to show the alarm event screen. If alarms are triggered
simultaneously in several channels, their full-screen images will be switched at an interval of
10 seconds (default dwell time).
3. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
4. Select the Full Screen Monitoring alarm linkage action.
5. Select the channel(s) in Trigger Channel for full screen monitoring.
6.4.2 Configure Buzzer
When an alarm is detected, the buzzer will make an audible beep.
Steps
1. Go to System → Live View → General .
2. Check Enable Audio Output.
3. Set the audio volume.
4. Click Apply.
5. Go to Linkage Action interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
6. Select Buzzer as the alarm linkage action.
Digital Video Recorder User Manual
92
Advertisement
Table of Contents
