Right Angle Attachment - Craftsman 572.61095 Owner's Manual

Right AngleAttachment53002
Before you begin, removethe black protective cap on
your attachment. If cap does not slide off easily, insert
the shank portion of any accessory through the
housing opening of the attachmentto hold shaft from
rotating. Then twist off. Figure 1.
Do not use the rotary !ool shaft
lock button when changing
accessorieson the attachment. Internal damage to
the attachmentmay occur.
Remove the housing cap from your existing rotary
tool as shown in Jig. 2. Thenpressthe shaft _ock
button on your rotary tool, unscrew the collet nut and
removethe collet.
Setyour collet nut and collet asideit will be
reinstalled later in step 4.
Install the drive adapter,included with your right
angle attachment,on the motor shaft asshown in
fig.3 and tighten.
Donot over tightendrive
adapter. Tighten the drive adapter
finger tight and then tighten an additional 1/3 turn
with the wrench. (Wrench included with your rotary
tool kit)
/
Screw the attachment onto your rotary tool. Hand
tighten only. Reassemblethe collet and the collet nut
from step 2, on to the output shaft of the attachment.
Figure4.
The right angle attachmentcan be oriented on your
rotary tool in 12 different positions. The attachment
should be positioned so the on/off speed control
switch is easy to access.
To reposition, unscrew the collar from the attachment
until disengaged. Slidethe attachmentoff. Then,
reposition, slide the attachment back on the tool and
retighten the collar. Figure5.
To changean accessory,insert the shank portion of
any accessory(3,2 mm recommended) through the
housing opening of the attachmentto hold the shaft
from rotating. With the shaft secured, loosen the
collet nut andinsert an accessoryas deeplyas
possibleto avoid wobble during use. You may needt(
pull backthe shank from the housing opening to
provide clearancewhile inserting the accessory.
Figure 6.
_ Attachmentcan becomehot afte
prolongusage.
2O