19,2 volt handheld inflator digital gauge (19 pages)
Summary of Contents for Craftsman 572.36578
Page 1
Sears OWNERS MANUAL MODEL NO. 572.36578 CAUTION: 115 VOLT A.C. Read Rules for SAW CHAIN Safe Operation and Instructions SHARPENER Carefully Introduction Assembly Operation Maintenance Repair Parts Sold by SE_RS, ROEBUCK AND CO_, Chicago, IL 60684 UoS A, FORM NO 380223 PRINTED IN U,S A...
Page 2
FULL YEAR WARRANTY CRAFTSMAN CHAIN SHARPENER _ --_._ For one year from the date of purchase, Sears will reptace this Crafts- man Saw Chain Sharpener, free of charge, if it falls to work properly_ WARRANTY SERVICE AVAILABLE RETURNING CRAFTSMAN SAW CHAIN...
Page 3
GROUNDING INSTRUCTIONS This too! shou}d be grounded while in use to protect COVER OF GROUNDED the operator from electricshock, Thetool is equipped OUTLET BOX with three-conductor cord three-prong grounding type plug to fit the proper grounding type receptacle. The green (or green and yellow) con- ductor in the cord is the grounding...
Page 4
STONE DIAMETER--Do not use grinding stones other than the 3 listed in the chain identification Your Craftsman Saw Chain Sharpener will sharpen chart. nearly all popular sizes of chain if you follow these simple instructions SAFETY--Protect...
Page 5
4 Securely mount the correct grinding stone in your F}gure 2 tool with approximately Y," of the shank exposed between the chuck cap and thestone, Figure2 Using the appropriate side (see column 2 of chart) of the guide gauge furnished, check to see if the guide is properly positioned with repect to the grinding stone, see Figure 4.
Page 7
35 ° LINE SHARPEN CUTTER TEETH GUIDE ONLY _ NOT THE DEPTH GAUGE ONE OF THESE LINES TO BE PARALLEL WITH CHAIN GUIDE BAR SEE COLUMN 5 OF CHART CHECK CHAIN TYPE(FIGURE 11) OR COLUMN 4 OF CHART. FOR PROPER TILT TO BE USED WHEN SHARPENING.
Page 8
CUTTER CONFIGURATION -- END VIEW CHISEL MICRO CHISEL CHIPPER SEMI CHISEL & MICRO BIT THESE TWO SHAPES OF CUTTER TEETH ARE SHARPENED THESE TWO SHAPES OF CUTTER TEETH ARE SHARPENED WITH THE GRINDING STONE TILTED AS SHOWN_ WITH THE GRINDING STONE HELD HORIZONTAL.
Page 9
TROUBLE SHOOTING IF YOUR DOES AS WELl. AS IT SHOULD AFTER SHARPENING OR tT DOES NOT CUT STRAIGHT, MAY HAVE A WORN OR DAMAGED GUIDE BAR, A WORN SPROCKET, OR DAMAGED LINKS IN THE CHAIN THIS BE CHECKED REPAIRED FOR YOU AT YOUR SEARS SERVICE...
Page 10
Check stone chain to cut Will cause size Hold sharpener excessive bottom wear correctly, HANGER -,.., STORAGE Your Craftsman Saw Chain Sharpener includes a hanger for + convenience and ease of storage as shown in Figure 9, PAGE 10...
Page 11
CRAFTSMAN CHAIN SHARPENER -- MODEL NUMBER 572.36578 The Model Number will be found on a plate attached to the Motor Housing Always mention the Model Number' in all correspondence regarding your Saw Chain Sharpener or when ordering repair parts SEE BACK PAGE FOR PARTS ORDERING...
Page 12
CRRI:TSMRI! ° Sears SAW CHAIN OWNERS MANUAL SHA PENE MODEL NO. The model Number will be found on the plate attached to the tool. Always mention the Model Numberwhen requesting service 572.36578 or repair parts for your Saw Chain Sharpener. parts listed herein...