Table of Contents
Advertisement
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Touch the X field.
1.
The control panel is automatically pushed forwards.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
3.
recess (Fig.
).
"
Press down on the lid along the seal to prevent
4.
water from leaking out of the water tank.
Remove the cover ‚ (Fig.
5.
Fill the water tank with cold water up to the "max."
6.
mark (Fig.
).
$
Reinsert the cover ‚ into the opening in the water
7.
tank.
Insert the filled water tank (Fig.
8.
water tank locks into place behind both holders ƒ
(Fig.
).
&
Slowly push the control panel downwards and then
9.
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
).
#
). Ensure that the
%
Refilling the water tank
If the water tank runs dry during a steam operation, a
message appears on the display prompting you to fill
up the water tank.
Notes
Steam-assisted operations continue without adding
■
steam.
If the water tank runs dry during the operation with
■
the Steaming, Dough proving, Reheating or
Defrosting settings, the operation is interrupted. Fill
).
!
the water tank.
Open the control panel.
1.
Remove and refill the water tank.
2.
Insert the filled water tank and close the control
3.
panel.
After every steam operation
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying function" operating mode or
dry the cooking compartment by hand.
Notes
Once the appliance has been switched off, the X
■
field remains lit for a little longer to remind you to
empty the water tank.
Remove limescale marks with a cloth soaked in
■
vinegar, then wipe with clean water and dry with a
soft cloth.
Emptying the water tank
Caution!
Do not dry the water tank in the hot cooking
■
compartment. This will damage the water tank.
Do not clean the water tank in the dishwasher. This
■
will damage the water tank.
Open the control panel.
1.
Remove water tank.
2.
Carefully remove the lid of the water tank.
3.
Empty the water tank, clean it with detergent and
4.
then rinse it thoroughly with clean water.
Dry all parts with a soft cloth.
5.
Rub the seal on the lid until dry.
6.
Steam
en
19
Advertisement
Chapters
Table of Contents
