Table of Contents
Advertisement
Steam
en
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Caution!
Malfunctions may occur when using filtered or
demineralised water.
The appliance may request that you top up the water
tank even though it may be full, or operation with steam
is cancelled after approx. two minutes.
If required, mix filtered or demineralised water with the
bottled non-carbonated mineral water with a ratio of
one to one.
Notes
If your water is very hard, we recommend that you
■
use softened water.
If you use only softened water, you can set your
■
appliance to the "softened" water hardness range.
If you use mineral water, set the water hardness
■
range to "4 very hard".
If you use mineral water, you must only use non-
■
carbonated mineral water.
Touch the
X
field.
1.
The control panel is pushed forwards automatically.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Lift the water tank and remove it from the water tank
3.
recess (Fig.
).
"
Press down on the cover along the seal to prevent
4.
water from leaking out of the water tank.
Take out the cover
‚
5.
Whether or not there is a cover
Note:
the appliance type.
Fill the water tank with cold water up to the "max."
6.
mark (Fig.
).
$
22
(Fig.
).
#
depends on
‚
Put the cover
7.
tank.
Insert the filled water tank (Fig.
8.
water tank locks into place behind both holders
(Fig.
).
&
Slowly slide the control panel downwards and then
9.
push it towards the rear until it is closed completely.
The water tank has been filled. You can start using
operating modes with steam.
Refilling the water tank
Notes
Steam-assisted operations continue without adding
■
steam.
).
!
If the water tank runs dry during the operation with
■
the Dough proving or Reheating setting, the
operation is interrupted. Fill the water tank.
Open the control panel.
1.
Remove and refill the water tank.
2.
Insert the filled water tank and close the control
3.
panel.
After every steam operation
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying function" operating mode or
dry the cooking compartment by hand.
Notes
Once the appliance has been switched off, the
■
field remains lit for a little longer to remind you to
empty the water tank.
back into the opening on the water
‚
). Ensure that the
%
ƒ
X
Advertisement
Table of Contents
