Descaling - Siemens HS858GX 1B Series Instruction Manual

Descaling

The appliance must be descaled regularly in order for it
to continue operating correctly.
There are several steps in the descaling programme.
For hygiene reasons, the descaling programme must
be run through completely so that the appliance can be
ready for operation again.In total, the descaling
programme runs for approx. 70-90 minutes.
Descale (approx. 55-70 minutes), then empty and
■
refill the water tank
First rinsing cycle (approx. 6-9 minutes), then empty
■
and refill the water tank
Second rinsing cycle (approx. 6-9 minutes), then
■
empty and dry the water tank
If the descaling process is interrupted (for example, due
to a power failure or because the appliance has been
switched off), you are prompted to rinse the appliance
twice after it is switched back on. The appliance cannot
be used until the second rinsing cycle has come to an
end.
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only five more steam-assisted operations are
possible, or fewer, the appliance reminds you to
descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Start
Caution!
Damage to the appliance: Use only liquid descalers
■
that are recommended by us for the descaling
programme. The time the product needs to work
during descaling depends on the type of descaler
used. Other descalers may damage the appliance.
Descaler order no. 311 680
Descaling solution: Do not allow any descaling
■
solution or descaler to come into contact with the
control panel or other delicate surfaces. This will
damage the surfaces. If this does happen, remove
the descaling solution immediately with water.
If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
Mix 400 ml water with 200 ml liquid descaler to
1.
make a descaling solution.
Press the On/Off button.
2.
Remove the water tank and fill with descaling
3.
solution.
Fully insert the water tank filled with the descaling
4.
solution.
Close the control panel.
5.
Press the Menu button.
6.
The operating modes menu opens.
Select the "Descaling" operating mode.
7.
If you touch the "Next" field, information on the
cleaning operation is displayed.
The duration of the descaling programme is
displayed. It cannot be changed.
Press the "Start/stop" button to start the cleaning
8.
operation.
The appliance is descaled. You can see the duration
counting down in the status bar. As soon as the
descaling programme has finished, an audible
signal sounds.
First rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the Start/Stop button to start.
4.
The appliance rinses. As soon as the rinsing cycle
has run through, a signal sounds.
Second rinsing cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Press the Start/Stop button to start.
4.
The appliance rinses. As soon as the rinsing cycle
has run through, a signal sounds.
Final cleaning
Open the control panel.
1.
Empty and dry the water tank.
2.
Switch off the appliance.
3.
Descaling is complete and the appliance is ready for
use again.
Cleaning function
en
27