Installation; Standards; Positioning; Wall Mounting - Riello MINI 17 LN NG Installation And User Manual

ENGLISH

3 INSTALLATION

3 1 Standards

The use of gas control boxes is subject to strict regulations. It is therefore
important that the UNI 7129 and 7131 standards are observed.
For liquefied petroleum gas (LPG), the installation must comply with the
requirements of the distributing companies and with the requirements of
the standards cited above.
The appliance is sold without the inlet and outlet device as a different
device is required according to the specific installation; please consult
the accessories catalogue to request any of the various different devices.

3 2 Positioning

- The appliance should be installed on a suitable wall and it is essential
that the minimum distances be left around it to allow for maintenance
work to be carried out (see section "Wall mounting").
- The appliance should not be positioned above a stove or other cooking
appliance so as to avoid kitchen vapour grease being deposited on it
and affecting operation.
- Heat-sensitive walls such as those made from wood should be protect-
ed with suitable insulation.

3 3 Wall mounting

3.3.1 Models for indoor installation

The appliance must be installed on a suitable wall:
- the appliance should never be closed in a unit or niche; there should be
a gap of at least 20 mm between the side walls and the appliance, so
maintenance work can be carried out;
20
- once the position of the appliance has been established, position the
template supplied and mark the position of the holes, then remove it
and drill 2 Ø 8 holes
L
28
20
200
Fig. 5
Fig. 6
Models 11-13
Models 17
- reposition the template and fix it with the plugs supplied
- the most common type of rear and horizontal outlet is described below;
Guide the wall template fins into the slots on the paper template
- mark the centre of the pipe hole;
- drill a hole Ø 110 mm as indicated on the paper template
Models 11-13
Models 17
- cut the pipes to the correct length according to the thickness of the wall.
If done correctly, the 60 mm Ø flue pipe should protrude by 7.5 mm with
respect to the 100 mm Ø air duct
- insert the specific pipe made up of two concentric pipes in the hole in
the wall
L
250 cm
320 cm
300
36.7
250
276
Fig. 7
380
320
346
Fig. 8