Table of Contents
Advertisement
Figure 112. Installing the front mounting front PERC module
Next steps
1. Reconnect all the required cables.
2. If removed,
install the air
3.
Install the drive backplane
4. Follow the procedure listed in
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
4. If applicable, disconnect the power or data cables from the expansion card(s).
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
110
Installing and removing system components
shroud.
cover.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Advertisement
Table of Contents
