Chapter 8: System Diagnostics And Indicator Codes; System Health And System Id Indicator Codes; Idrac Direct Led Indicator Codes - Dell PowerEdge T350 57C92 Installation And Service Manual

Table of Contents

Advertisement

System diagnostics and indicator codes
This section describes the diagnostic indicators on the system front panel that displays the system status during system startup.
Topics:

System health and system ID indicator codes

iDRAC Direct LED indicator codes

NIC indicator codes
Power supply unit indicator codes
Non-redundant cabled power supply unit indicator codes
Drive indicator codes
Using system diagnostics
System health and system ID indicator codes
The system health and system ID indicator is located on the front panel of the system.
Figure 107. System health and system ID indicator
Table 26. System health and system ID indicator codes
System health and system ID
indicator code
Solid blue
Blinking blue
Solid amber
Blinking amber
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or
tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table
describes iDRAC Direct activity when the iDRAC Direct port is active:
120
System diagnostics and indicator codes
Condition
Indicates that the system is powered on, is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Indicates that the system is in fail-safe mode. If the problem persists, see the
help
section.
Indicates that the system is experiencing a fault. Check the System Event Log
for specific error messages. For information about the event and error messages
generated by the system firmware and agents that monitor system components, go
to
qrl.dell.com
> Look Up > Error Code, type the error code, and then click Look it
up.
8
Getting

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emc poweredge t350

Table of Contents