Table of Contents
Advertisement
Figure 91. Installing an expansion card into a Riser 2b (SNAPI)
Figure 92. Installing an expansion card into a Riser 2c
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller, FC, or NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For updating to
the latest firmware and changing the configuration, see the Lifecycle Controller User's Guide at
idracmanuals.
After working inside your
system.
Installing and removing system components
https://www.dell.com/
93
Advertisement
Table of Contents
