General Pipe Cleaners JM-3000 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. General Pipe Cleaners Manuals
  4. Pipe cleaners
  5. JM-3000
  6. Operating instructions manual

General Pipe Cleaners JM-3000 Operating Instructions Manual

Gas jet
Hide thumbs Also See for JM-3000:
Table of Contents

Advertisement

Quick Links

Download this manual
Your JM-3000 Jet-Set gas-powered
water jet is designed to give you years of
trouble-free, profitable service. However,
no machine is better than its operator.
Read, understand and follow all safety
warnings and instructions provided with
the product. Failure to follow the warn-
ings and instructions may result in elec-
tric shock and/or serious injury. Save all
warnings and instructions for future refer-
ence.
SAVE THESE INSTRUCTIONS!
JM-3000
Operating Instructions
™
Gas Jet

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JM-3000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for General Pipe Cleaners JM-3000

Summary of Contents for General Pipe Cleaners JM-3000

  • Page 1 ™ JM-3000 Gas Jet Operating Instructions Your JM-3000 Jet-Set gas-powered water jet is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. Read, understand and follow all safety warnings and instructions provided with the product.

  • Page 2: Safety Symbols

    JM-3000. Do not direct discharge stream at peo- SAFETY SYMBOLS ple. This equipment can produce a high...

  • Page 3: General Safety Rules

    Jet-Set JM-3000™ GENERAL SAFETY RULES JET SAFETY 1. Do not operate jet above rated pressure or above 140 degrees (rated water temperature). Operating jet above rate specifica- WARNING tions risks damage to the pump and related components, and will Read and understand all instructions. Failure to follow all in- void the warranty.

  • Page 4: Jet Nozzles

    Jet-Set JM-3000™ REMOVABLE HOSE REEL 3. Check nozzles before and after each use for clogged holes which can cause pressure to increase to dangerously high levels and This Jet features a removable hose reel. It easily detaches in sec- damage the pump. A clogged hole can be cleared by simply using onds for remote operation.

  • Page 5: Operation

    Jet-Set JM-3000™ NOZZLE SELECTION GUIDE Connect one end of a water supply hose (not included) to the water supply and the other end to the water inlet of the jet ma- HOSE SIZE 1/8” 1/4” 3/8” chine. Water supply must be a minimum of 20 psi and not to exceed 100 psi.

  • Page 6: Special Applications

    Jet-Set JM-3000™ OPERATION CONTINUED SPECIAL APPLICATIONS 9. Guide the jet hose into the drain line. Do not feed the hose contin- ICE BLOCKAGES uously, but rather, move the hose forward and back to allow the pressure to break up the stoppage and the water flow to flush it High pressure water can be used to clear an ice blockage.

  • Page 7: Maintenance

    Jet-Set JM-3000™ The Spray Wand can be used to clean your truck or other applica- ACCESSORIES tions. Caution: Never clean the machine with its own spray. Follow HANDY-REEL WITH FOOT PEDAL the same procedures listed previously for safety, set-up, operation, - Cat # HM-200-W (OPTIONAL) and maintenance.

  • Page 8: Troubleshooting Guide

    Jet-Set JM-3000™ TROUBLE SHOOTING GUIDE Problem Probable Cause Solution Low pressure. Worn, clogged, or oversized nozzle. Clean or replace worn nozzle. Check nozzle size. Clogged water inlet strainer. Clean or replace strainers. Inadequate water supply. Make certain water supply valve is on fully. Make certain water supply hose is at least 3/4”...
  • Page 9 Jet-Set JM-3000™ TROUBLE SHOOTING GUIDE continued Problem Probable Cause Solution Washer fails to draw detergent. Detergent metering valve closed, or Open detergent metering valve, following procedure in operating valve clogged or defective. instructions. Back pressure in hose (when using Contact dealer for proper injector size when adding lengths of additional lengths of pressure hose).
  • Page 10 67 U CLAMP JM13-0211 26 CABLE JM32-9112 68 PRESSURE GAUGE JM22-0465 27 DECAL - RISK OF BURNS 69 DECAL - JM-3000 CONTROL PANEL (SEE JM71-0008) (SEE JM71-0008) 28 DECAL - RISK OF FIRE 70 ELBOW JM23-0426 (SEE JM71-0008) 71 COUPLER...
  • Page 11 Jet-Set JM-3000™...
  • Page 12 Jet-Set JM-3000™ JM-3000 PUMP/GEARBOX PARTS LIST ITEM DESCRIPTION PART # PUMP JM3-0203 GEARBOX JM47-0032 VALVE CAP JM46-1427...
  • Page 13 Jet-Set JM-3000™ JM-3000 PUMP PARTS LIST (Drawing on next page) ITEM DESCRIPTION PART # ITEM DESCRIPTION PART # VALVE PLUG JM46-0889 RETAINING RING JM46-0103 O-RING JM25-0012 CONNECTING ROD PIN JM43-0032 VALVE ASSEMBLY (INC. 11-15) N/A SEP. OIL LEVEL INDICATOR JM46-0114...
  • Page 14 Jet-Set JM-3000™...
  • Page 15 Jet-Set JM-3000™ JM-3000 GEARBOX PARTS LIST ITEM DESCRIPTION PART # ITEM DESCRIPTION PART # O-RING JM25-0158 SPACER JM46-1474 PUMP FLANGE JM46-1472 WASHER JM28-0139 SEALING WASHER JM28-0137 LOCKWASHER JM29-0155 SCREW JM27-8434 SCREW JM27-0119 O-RING JM25-0650 OIL PLUG VENTED JM46-1475 SET SCREW...
  • Page 16 Jet-Set JM-3000™ JM-3000 HOSE REEL PARTS LIST ITEM DESCRIPTION PART # ITEM DESCRIPTION PART # LOCKNUT JM30-0157 WASHER JM28-0002 WASHER JM28-0003 LOCKNUT JM30-0155 3/8" SWIVEL JM24-0362 HOSE REEL STAND JM20-1221A01 HOSE JM15-0311 BOLT JM27-0066 ELBOW JM24-0105 HOSE REEL JM50-0221 SCREW COUPLER...

This manual is also suitable for:

Jm-3000-a

Table of Contents