Regulatory - Globalstar ST150 User Manual

9150-0125-01 R-4

13 REGULATORY

Radio Astronomy Site Avoidance
The ST150M complies with FCC CFR25.213. The customer end-product must comply with the requirements
for Radio Astronomy avoidance. See Globalstar document GS–07–1248 REMOTE TELEMETRY SERVICE
FREQUENCY PLAN FOR SIMPLEX TRANSMITTERS for more details.
Regulatory Notices
The ST150M Board has received Federal Communications Commission authorization under FCC Rules Part
25 and Part 15C as a modular transmitter. Final installation must be in compliance with 25.213 (see section
6 above). Integrators must complete final end-product certifications dependent upon their end application's
use. The installation and operating configurations of this transmitter must satisfy MPE categorical Exclusion
Requirements of 2.1091. The antenna used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter.
The ST150M module will satisfy FCC/IC modular transmitter requirements only when used with the antenna
type specified in Section 5.4. No power amplifiers may be used under the terms of this modular approval. No
trace antennas or any other type of antenna are approved for use under the terms of this modular approval. It
is permissible to use different antenna manufacturers provided the same antenna type that has similar in-
band and out-of-band radiation patterns and antenna gain (equal to or less than the antenna gain listed
above) is used. The module provides a surface mount pad for the RF output which must be internally attached
passively via the PCB to the approved antenna. No antenna connector, cable, or any other type of antenna may
be used. In order for any device to obtain certification from Globalstar for use on the Globalstar satellite
network under this modular approval, all conditions listed above must be met. Use of any antenna other than
those listed in Section 5.4 will require proof of compliance (peak gain). This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's license-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
NOTE: Any additional host device the module is integrated into will require regulatory testing and certification (C2PC for FCC
and C4PC for ISED).
ST150M User Manual Confidential & Proprietary Information
68