Important Safety Instructions; Troubleshooting - MTI BASICS MBRO7236EWH Owner's Manual

I M P O R T A N T S A F E T Y I N S T R U C T I O N S
WARNING : When using electrical products, basic precautions should always be followed, including
these: (Please read and follow all directions. Save these instructions.)
1. DANGER: To reduce the risk of injury, do not allow children or infirmed persons to use this
2. This MTI BASICS hydrotherapy unit is designed for use only as described in this manual. Do
3. Do not drop or insert any object into any opening.
4. Do not operate this tub without the guard over the suction fitting (water intake). The guard is
5. Anyone under doctor's care, pregnant, or whose health is poor should check with a
6. Recommended length of hydrotherapy bath is 10 minutes. However, if you become dizzy or
7. Do not use immediately after eating or while under the influence of drugs or alcohol.
8. Before servicing unit, shut off all electrical outlets as more than one outlet may be energized.
A: Check the electrical connections. Test the outlet for power by plugging in a small lamp or hair dryer.
Check to make sure the breaker is not tripped. Replace GFCI outlet or breaker if necessary.
A: Check the rubber "O" rings for proper seating. Tighten the large union nut rings on the pump. These
may have loosened during shipping or installation. Do not over tighten.
A: Each jet can be opened and closed individually. Check each jet by turning the jet escutcheon to ensure it's open.
A: The in-line heater has a separate power cord. Make sure the pump and heater are both plugged into working
receptacles. The indicator light on the top of the heater will glow, indicating it is functioning properly. Keep in mind,
the in-line heater will not heat your water; it will just maintain the water temperature up to 103 degrees.
the manufacturer's instructions, and then clean the interior of the tub with a mild, grease cutting dish soap.
A: The on/off control may have been unplugged during installation. Check that the on/off control is
connected to the blower, and the blower is plugged into a working receptacle. Check that the grey air hose
from the air blower to the manifold is properly connected. If necessary, reconnect and tighten clamps.
Q. My MTI air bath appears to just turn on even if we are not in the tub.
A. Each MTI BASICS air bath is designed to purge 20 minutes after the system is turned off. This is
normal, and helps keep the bath dry and sanitary.
8
Pertaining to a Risk of Fire, Electric Shock, or Injury to Persons
product unless they are supervised at all times.
not use attachments not recommended by the manufacturer.
a safety device that reduces the potential hazard of hair or body entrapment. Keep hair and
body away from suction guard when pump is running.
physician before using any whirlpool bath system.
nauseous or develop a headache, get out at once and cool down. Get medical attention if
symptoms persist. Also check with your physician before using this system again.
TROUBLESHOOTING Q & A