Honeywell MetroSelect Eclipse MS 5145 Configuration Manual page 62

³ 1 1 5 8 1
³ 1 1 5 8 0
³ 1 2 4 5 1
³ 1 2 4 5 0
³ 1 2 4 5 1
³ 1 2 4 5 0
³ 1 2 4 5 1
³ 1 2 4 5 0
³ 1 2 4 5 1
³ 1 2 4 5 0
³ 1 1 5 8 1
³ 1 1 5 8 0
* Character RTS/CTS – Activates/Deactivates
RTS signal for each character.
5
Message RTS/CTS – Activates RTS before
sending the first character and leaves it active
5
until after the last character has been
transmitted.
Invert RTS Polarity (RSV1)
-12V = Active
0
* Standard RTS Polarity – Use standard RTS
polarity
0
-12V = Inactive
Invert CTS Polarity (RSV2)
-12V = Active,
1
OK to send
* Standard CTS Polarity
-12V = Inactive,
1
Do not send
Activate RTS, Do Not Wait for CTS (RSV3) –
Activate RTS for transmission but do not wait for
2
CTS to send.
* Activate RTS, Wait for CTS – Wait for CTS after
activating RTS.
2
Test CTS Not Present Before RTS (RSV4) – Do
not activate RTS if CTS is already present.
3
* Do Not Test for CTS Present Before RTS
3
Enable DTR Support – The scanner will stop
scanning when the Data Terminal Ready (DTR)
7
signal goes inactive.
* Disable DTR Support
7
+12V = Inactive
+12V = Active
+12V = Inactive,
Do not send
+12V = Active,
OK to send
10–3