Honeywell MetroSelect Eclipse MS 5145 Configuration Manual page 106

³ 1 2 0 3
Continuous Blinky Mode
³ 4 1 8 3
Sleep Mode
³ 9 1 9 5
Detect and Notify Mode (Monitor the External
Trigger) – The external I/O pin used in the default
1 3
activation mode is monitored during the inactive
laser cycles. An <SI> is transmitted when the I/O
is active and an <SO> when it is inactive. Once
the scanning activation cycle is started, the
external I/O monitoring status is maintained until
the scanning cycle is terminated regardless of the
actual I/O level.
Continuous Blinky Mode – The scanner will
continuously blink on and off, turning the scanning
3 4
cycle on and off for all normal scanner operations.
If a bar code is scanned and transmitted, the same
symbol timeout is maintained throughout the cycle
preventing additional scans of the same bar code
when the scanner is in default mode.
~ Sleep Mode – A power saving mode that can
be configured to occur in 1-second increments.
0 0
Use this code with a code byte sequence
(on page 16–1) that represents the desired
increment.
22–3