What to purchase - or What did I Purchase? There are two versions of the Metrologic MS9535 Voyager BT. One with inventory memory, and one without. Yet, both versions allow you to scan and store (record) scans and later allow you to play them back into the system.
Page 4
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Note: I found that you could do this step before #1 or #2 above. If you cannot get the blue LED light to stay on -- something is wrong at this point, and it is rather pointless to continue further here.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION If you are going to scan the barcodes into the system one at a time, then you do not need to set Range Gate or Inventory mode. Also, if you are...
Page 6
(click-in) the bulk entry form. if you are anywhere else, you will lose your scan data and will not be able to replay the data. Don't call us -- don't call Honeywell either -- it is a feature of the scanner.
Honeywell Support below. Honeywell Support Honeywell support is among the best I have experienced. The folks at the end of the line really do seem to know their product and/or can get the answer for you quickly.
Page 8
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Key Barcodes The following barcodes are the only ones you would normally need to deal with. Reset to factory defaults (scan both) To set the scanner back to factory defaults, scan both scans below. An "ET" 3-beep sound should play.
Page 9
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Only if you have the -5M Extended memory MS9535 Voyager BT Page -1 Updated: June 2010...