Honda CRF1000L Owner's Manual page 168

Tyre Puncture
u
Install the right brake caliper and tighten
8.
new mounting bolts.
Torque: 45 N·m (4.6 kgf·m, 33 lbf·ft).
Install the left brake caliper and tighten
9.
new mounting bolts.
Torque: 45 N·m (4.6 kgf·m, 33 lbf·ft).
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the brake caliper.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Lower the front wheel on the ground.
10.
Apply the brake lever several times. Then,
11.
pump the fork several times.
162
Removing Wheels
Retighten the right axle pinch bolts.
12.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft).
Raise the front wheel off the ground
13.
again, and check that the wheel rotates
freely after you release the brake.
14.
ED, II ED, III ED, IV ED, II KO, III KO, IV KO
type only
Install the front axle nut cap.
Remove the protective tape or cloth.
15.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.