Honda CRF1000L Owner's Manual page 139

Tighten the rear axle nut.
7.
Torque: 100 N·m (10.2 kgf·m, 74 lbf·ft)
Hold the adjusting bolts and tighten the
8.
lock nuts.
Torque: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Recheck drive chain slack.
9.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Drive Chain Adjusting the Drive Chain Slack
u
# Checking the Drive Chain Wear
Check the chain wear label when adjusting
the drive chain. If the indicator groove on the
adjusting plate enters the red zone on the
label after the chain has been adjusted to the
proper slack, the chain is excessively worn
and must be replaced.
Chain: DID 525HV3
If necessary have the drive chain replaced by
your dealer.
Indicator
groove
Red zone
133