Table of Contents
Advertisement
Using Projector Menu 3
Press
/MENU button to enter projector menu, press
OSD Language
Flip
Power Saving Mode
Aspect Ratio
Restore Factory Default
Software Update (USB)
USE
TO SELECT
OSD Language English
PRESS OK
USE
TO SELECT
Flip Front Table
OK
OK
OK
PRESS OK
USE
USE
USE
TO SELECT
TO SELECT
TO SELECT
Power Saving Mode On
PRESS OK
PRESS OK
PRESS OK
USE
USE
USE
TO SELECT
TO SELECT
TO SELECT
Aspect Ratio 16:9
PRESS OK
PRESS OK
PRESS OK
USE
TO SELECT
Restore Factory Default
PRESS OK
USE
TO SELECT
USE
Software Update (USB)
PRESS OK
Aspect Ratio
AV mode
HDMI mode
VGA mode
USB / TF input (movie mode)
Note:
1.
Power Saving Mode is default On when the unit is active the battery mode.
2.
When the Power Saving Mode is turned on, the projection brightness will be dimmed. If
you want to change the brightness, turn off the Power Saving Mode.
3.
Plug in the DC supply, the Power Saving Mode is not Active, the projection brightness is
normal.
English
This OPTION menu showed on right upper of viewing
Front Table
screen.
On
16:9
Use
To select different project direction Front Table / Front
t
Ceiling / Rear Table / Rear Ceiling
To select On / Off
(Active in battery mode, i.e. unplug DC IN jack power.)
Use
t
t
t
Follow below figure.
Use
t
unit will go to factory default setting.
For service center use only
4:3, 16:9, Full, Panorama
4:3, 16:9, Full, Just Scan
4:3, 16:9, Full
4:3, 16:9, Full, Panorama, Just Scan
button to select OPTION menu.
button to select different language.
to select different Aspect Ratio 4:3 / 16:9 / Full
buttons to select Y or N. If choose "Y" that your
17
Advertisement
Table of Contents
