Page 2
This product has been manufactured and sold under the responsibility of CURTIS INTERNATIONAL LTD. RCA, the RCA logo and the two dogs (Nipper and Chipper) logo are trademarks used under license by CURTIS INTERNATIONAL LTD. – further information at www.rca-brand.com.
Page 3
3. Heed all Warnings. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other appara ) that product heat. convenience receptacles, and the point where they exit from the apparatus.
Page 4
1. Do not look directly into the projector light. 2. Don’t touch the project lens 3. Mains adapter is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely.
FCC Warning This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Projector Remote MENU Power: Press to power ON. POWER ON Press twice to power OFF. Mute: Press to mute volume. HOME MENU VOL+ /VOL-: Press to adjust audio level. Arrows / OK : Press to navigate and confirm NAVIGATOR selections in Settings and other menus. BUTTONS Return/ Exit: Press to exit the projector menu.
Controls Of Projector 8 910 11 12 13 14 1.Right 10.HDMI Port 1 2.Source 11.HDMI Port 2 3.Left 12.HDMI Port 3 4.Return 13.USB Port 1 5.OK/Power 14.USB Port 2 6.Keystone Correction 15.IR Window(Back Side) 7.Focusing Ring 16.Power Input 8.Headphone Jack 17.IR Window(Front Side) 9.AV 18.Lens...
Page 12
Return Right Left OK/Power Press to navigate on- screen menus and make selections. Long press to power on/off the projector. TURN ON 1) Plug the projector into a power source, Indicator light:Red. 2) Press the power button . Indicator light: White. 3) The projector turned on after 5 seconds.
Connection Instructions Select an input source You will see the picture below when the projector is turned on. HDMI1/HDMI2/HDMI3) by pressing the arrows buttons(UP/DOWN/LEFT/RIGHT) on the projector touch panel or remote control. connection instructions. Interface HDMI device connection The projector can connect to devices with HDMI input function. It is compatible with laptops, DVD players, Blu-ray players, Chromecast, TV Stick, etc.
Multimedia connection Insert USB into the corresponding slots (as shown in the picture). Select “ MOVIE”, “MUSIC”, “ PHOTO” to enter the content you want to play. Sub-Menu on Photo screen When photo playback, press the button and more function screen show on lower (figure 1).
AV video device connection Connect the projector AV interface with the AV cable, as is shown in the pictures. Video Cable: YELLOW Audio Left Channel: WHITE Audio Right Channel: RED Female AV Cable(not include) AV OUT Portable DVD Player/Video Player Male AV Cable(not include) Projector Audio devices connection...
PROJECTOR SETTING Options Related to “PICTURE” are set on this screen Press button to enter projector menu. Press again to previous status. buttons to select manual page. PICTURE Picture Mode Standard This manual showed on Contrast AUDIO right upper of view Brightness Color OPTION...
PROJECTOR SETTING Options Related to “AUDIO” are set on this screen. Press button to enter projector menu. Press again to previous status. buttons to select manual page. PICTURE Sound Mode Standard This manual showed on Treble AUDIO right upper of view Bass Balance screen.
PROJECTOR SETTING Options Related to “OPTION” are set on this screen. Press button to enter projector menu. Press again to previous status. buttons to select manual page. This manual showed on PICTURE OSD Language English Aspect Ratio 16:9 right upper of view AUDIO Projection mode Front...
PROJECTOR SETTING Options Related to “TIME” are set on this screen. Press button to enter projector menu. Press again to previous status. buttons to select manual page. PICTURE Clock This manual showed on Off Time SOUND On Time right upper of view Sleep Timer OPTION screen.
Page 20
Light Source Type Brightness Output White light output ANSI: 450 lm Display Native Resolution 1920 1080 HDMI Input Supported 1080p , 1080i , 720p, 576i , 480p,480i Video Resolution. Power Consumption Operating 150W; Standby 0.8W Power Input DC 35V , 4.28A Connect Included Adapter Included Adapter Input AC100-240V,50/60Hz...
TROUBLESHOOTING please contact Customer service: 1-800-968-9853. Before resorting the maintenance service, please kindly check by yourself with the following chart. Symptom Cause (and Remedy) 1.Power light is on. If it is not on, check the projector is plugged into the mains, that the socket is switched on, and then press the power button on the projector.
Page 22
First, make sure the projector is turned on and set to the HDMI 3 input. Then press a button on the remote control to ensure that the device is not in standby or screen saver mode. Listed below are the most common reasons you may not see video on your projector: 1.
Need help?
Do you have a question about the RPJ167 and is the answer not in the manual?
Questions and answers