Page 1
PLEASE READ BEFORE OPERATING THIS EQUIPMENT This product is manufactured and sold by Curtis International Ltd. RCA, the RCA logo, the two dogs (Nipper and Chipper) logo, are registered trademarks or trademarks of RCA TrademarkManagement and are used under license by Curtis International Ltd. Any other product, service, company, trade or product name and logo referenced herein are neither endorsed nor sponsored by RCA Trademark Management or its affiliates.
Page 2
3. Heed all Warnings. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifier) that product heat. convenience receptacles, and the point where they exit from the apparatus.
Page 3
1. Do not look directly into the projector light. 2. Don’t touch the project lens. 3. Mains adapter is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected from the mains socket outlet completely.
PLEASE READ BEFORE OPERATING THIS EQUIPMENT PQRS WXYZ This product is manufactured and sold by Curtis International Ltd. RCA, the RCA logo, the two dogs (Nipper and Chipper) logo, are registered RECALL FAV/ trademarks or trademarks of RCA TrademarkManagement and are used under license by Curtis International Ltd.
Remove & Close The Lens Cover Remove the lens cover before using Close the lens cover when unit not using CLOSE REMOVE LENS COVER LENS COVER Placing Your Projector Your projector can be installed in four different configurations (see picture below): Front Table: Front Table Select this location with the projector placed near...
• Move the projector as close to the center of the screen as possible. • The light beam from the projector should be perpendicular to the screen for a rectangular or square image. Distance Between The Projector And Screen Measure the distance between the projector and where you want to position the screen.
Follow below picture to adjust the vertical location. SCREEN SCREEN PROJECTOR VERTICAL VERTICAL DIMENSION DIMENSION PROJECTOR HDMI SCREEN VERTICAL DIMENSION PROJECTOR Adjust this knob ( ANGLE ADJ. knob) to fine- tune the display angle to higher. Adjust The Focus And Keystone Follow below picture to adjust the focus and trapezoidal screen.
Controls Of Remote FLIP EXIT MENU EXIT PQRS WXYZ RECALL FAV/ Remove the battery compartment cover on the back of your remote by carefully sliding to open. The battery cover can then be lifted away. Fit the correct batteries (not included), referring to the polarity markings. Finally, replace the cover.
Install Power Adapter Follow below picture to connect power adapter Connect small end of adapter FIRST. Plug the adapter body to power outlet. WARNING: Before connecting to the power supply, ensure that the supply corresponds to the information on the rating label at the back of the apparatus.
Connect HDMI Show The Image On Projector Screen Refer to the following picture to connect a set top box, a BD/DVD player or a streaming player to the HDMI input. 1. Turn off the unit before connect HDMI cable. 2. After connection, press the button to turn on unit and power indicator will light GREEN 3.
Connect VGA Show The Image On Projector Screen Follow below picture to connect VGA cable and device. Turn off the unit before connect VGA cable. Press the button to turn off power of your projector before connection. After connect, press the button to turn on unit and power indicator will light GREEN Press the...
Connect Audio Output ( Aux Out / Line Out / Earphones) Follow below picture to connect audio cable and device. Press the button to turn off power of your projector before connection. Use audio cable to connect follow below figure. After connect and turn on both units.
Using TF Card And USB Playback (Media Player) Install USB / TF device: Turn off the unit before install USB / TF card. Install the USB device into USB port / Install the TF device into TF slot. Press the NOTE: Sub-Menu on Photo screen Figure 1.
Using Projector Menu 1.0 Press button to enter projector menu. Picture Mode Standard This Picture menu showed on right upper of Color Temperature view screen. Aspect Ratio Auto Noise Reduction PC Setting Reduce Display 100% TO SELECT to select different picture effect to Standard / Soft / User / Vidid.
Using Projector Menu 2.0 Press button to enter projector menu, press buttons to select SOUND menu. Sound Mode Standard Balance 0 This SOUND menu showed on right upper of view screen. Auto Volume Off TO SELECT to select different sound effect Standard / Music / Movie / Sports / User.
Using Projector Menu 3.0 Press button to enter projector menu, press buttons to select OPTION menu. OSD Languag h s a i l g n Restore Factory Default This OPTION menu showed on right upper of Rotate 0 view screen. OSD Duration 30 S Software Update(USB) TO SELECT...
Specifications Light Source Type Brightness Output (LED) 2000 lumens Display Native Resolution 800 x 480 RGB HDMI Input Supported 1080p , 1080i , 720p, 576i , 480p, and 480i Video Resolution. Power Consumption Operating 30W; Standby 1.1W Power Input DC 12V , 2.5A Connect Included Adapter Included Adapter Input AC100-240V,50/60Hz...
Page 20
LIMITED PRODUCT WARRANTY This quality product is warranted to be free from manufacturer’s defects in material and workman-ship, provided that the unit is used under the normal operating conditions intended by the manufacturer. Should you have any problem with this product, please and it is highly recommended to visit our website at www.curtisint.com before you take any other steps as we have additional copies of instruction manuals, operating manuals and trouble shooting tips on our website which gives you the answer on most of the questions you could have in operating the unit.
Need help?
Do you have a question about the RPJ116-PLUS and is the answer not in the manual?
Questions and answers