MICODUS MV720 - GPS tracker Manual
  1. Manuals
  2. Brands
  3. MICODUS Manuals
  4. GPS
  5. MV720
  6. User manual

MICODUS MV720 - GPS tracker Manual

Also See for MV720:

Advertisement

Table of Contents
Contents
MICODUS MV720 - GPS tracker Manual

Learn how to set up your new MiCODUS Tracker

Main Features

Main Features

Specifications

Device Information Model MV720
Weight 53g
Dimensions 31mm(L) * 31mm(W) * 57mm(H)
Working Parameters Working Voltage DC 9-90V
Working Current <30 mA
Sleep Current <15 uA
Battery Capacity 3.7V 80mAh Lion Polymer battery
Working Temperature -20℃ - 75℃
Working Humidity 10%-85%RH non-condensing
Cellular Specifications Working Frequency 2G GSM/GPRS: 850/900/1800/1900MHz
SIM Card Nano SIM Card
Cellular Antenna Built-in
GNSS Specifications Positioning Type GPS+GLONASS+LBS
GPS Antenna Built-in
Cold Start ≤32 Seconds
Hot Start ≤1 Second
Tracking sensitivity -162 dBm
GPS Channels 64
Position Accuracy 5-10m

How to manage the tracker to get online?

Step 1

Manage the tracker to get online - Step 1

Please get a suitable SIM card from your local place. The SIM card must meet below points:

  • It must be compatible with the 2G GSM network
  • Please enable SMS, call, internet data traffic of the SIM card
  • Enable the caller ID display feature
  • Remove the PIN code
  • Use Nano size SIM card for the tracker
  • Please inquire the SIM card provider for the exact correct APN information

Step 2 SIM card installation

SIM card installation

Step 3 Wiring

Wiring

warning NOTE: After installed SIM card correctly, it is very important to connect the tracker with external power no less than 12V for power supply before operation!

Step 4 Configure APN

Please get the exact correct APN name from local SIM card provider. Take the tracker to a good signal place for operation and configure the APN for it as below:

SMS Command Format Reply Example Note
apn123456+space+ apn name apn ok apn123456 cmnet Please get the exact correct APN name from local SIM card provider."cmnet" is just an example of APN name.
apnuser123456+ space+apnuser apnuser ok apnuser123456 cmnet lf the SIM card operator doesn't have APN user name, then please ignore this configuration
apnpasswd123456+ space+apnpassword apnpasswd ok apnpasswd123456 123

Note: The APN information is very important, it must 100% correct to match with the sim card of the tracker, if you configured wrong APN, the tracker also will reply "SET APN ok" but it will can't get online!

Step 5 Indicator status description

LED Event State
GSM LED (GREEN) Searching for network Solid
Network has been registered Flash every 1 second
GPS LED (Blue) GPS is in fixing Solid
GPS has fixed Flash every 1 second
ALL LED Device is working but stopped more than 5min ALL LED TURN OFF
Device has not been turn on
Device ran out of battery

Package Content

GPS Main Unit x 1
Function Cable x 1
Pick x 1
User Guide x 1
Genuine Packing Box x 1

Functions Explanation

Please follow with the quick user guide carefully!

Vibration Alert

For example:

This vibration alert function just work under stationary status. How to use this function:

  • Set admin number by this SMS command: admin123456+space+mobile number with country code
  • Enable the device to enter into arm mode by this SMS command: 111
  • Configure the alarm ways by this SMS command: vibalm123456
  • Keep the device under stationary status more than 5min to let it enter into sleep arm mode;
  • Vibrate the device then the tracker will send the vibration alarm messages

Cut Off Fuel/Resume Fuel

For example:

  • Set admin number by this SMS command: admin123456+space+mobile number with country code
  • Send this SMS command from the admin number to cut off fuel: 555

warning NOTE: About the cut off fuel function, firstly please make sure the fuel circuit is connecting to main power. Secondly, it has 3 different performance, please read it carefully:

  • If the network signal and satellite signal both are available, when the equipment speed exceeds 20km/h, the fuel circuit will not be cut off immediately, it will cut off intermittently till the speed is below 20km/h, then just can be completely cut off.
  • In the tracker has network signal and but no satellite signal, the fuel circuit will be cut off intermittently, after 2, 3 minutes it will be cut off completely;
  • If the tracker stopped more than 5 minutes, the fuel circuit will be cut off immediately, and then connected, but if you vibrate the tracker or vibrate the tracker the fuel circuit will be cut off immediately;

Installation Recommendation

Installation

  1. The device should face up to the sky.
  2. Metal thermal barrier of heating layer of the windshield affects the signal.

Troubleshooting

Type Use
Unable to connect to tracking platform Check the APN and settings.
Check whether the data service of SIM card is enabled.
Check the balance of SIM card.
Tracker shows offline Check whether external power is still connected.
Check if the vehicle entered network blind area.
Check the balance of SIM card.
Unable to locate Make sure the top side facing upward without metallic things shielded.
Make sure it's not in area with no satellite coverage.
Location drift In area with poor GNSS signal (tall building around or basement), drifting may happen.
Check whether vibration happens around to trigger the accelerator.
No command reply Make sure command format is correct.
Vehicle may be in network blind area.
Make sure SIM card is well inserted and has SMS service.

Full SMS Commands List

Functions Command Format Explanation
Set Admin Number admin123456+space+mobile number with country code Please add your country code as prefix of the admin number
Back to Factory Setting begin123456 After sent this SMS command, all your configuration will be cleared and the device will get back to factory default settings
Password Change password+old password+space+new password The password just can be 6 digitals
Restart rst After sent this SMS command, the configurations will be saved and the device will restart
APN apn+123456+apn content Please get the exact correct APN name from the SIM card provider of the tracker, "cmnet" is China Mobile's APN name
apnuser+123456+space+content If the SIM card operator doesn't have APN user, then please ignore this configuration
apnuser+123456+space+content If the SIM card operator doesn't have APN password, then please ignore this configuration
IP&Port adminip+123456+space+ip +space+port Micodus tracking platform's IP: 47.254.77.28; Port: 7700
Domain SZCS,123456,DOMAIN=d.micodus. net: 7700 MiCODUS server domain: d.micodus.net, Port: 7700
Google Maps Link G123456# or where V:A: Indicates the device has GPS signal;
V:V: Indicates the device doesn't have GPS signal;
2019-11-26 10:17:01: Date and Time;
S: 000km/h: Speed of the tracker
Bat: 5: Battery level of the backup battery of the tracker, it has 6 levels: "6" means 100%, "5" 80%, "4" means 60%, "3" means 40%, "2" means 20%, "1" means 10%;
ACC: off: The status of the car engine;
7201000006: ID number of the device;
S26: GSM signal is 26
G06: GPS signal is 06
p: 46000, l: 13152, c: 63162: p, l,c this 3 parameters means the LBS code
Data Upload Frequency upload123456+space+time Time interval scope: 10-180s
Time Zone timezone+123456+space+GMT No. If east time zone, needn't input sign "+", for example, if the time zone is East 8, then the SMS command should be sent like this: timezone123456 8
Parameter Query param1 firmware version ID, IP, port, domain, APN
param2 admin number, SOS number, move distance, overspeed, auto arm time, auto disarm time, alarm interval
Status status BAT: 10 GPRS: GSM: GPS:A/V ACC:on/off oil: on/off power: on/off
Arm 111 or SF
Disarm 000 or CF
Cut Off Fuel 555
Resume Fuel 666
Movement Alarm move+alarm distance Movement alarm distance scope: 100-1000m
Overspeed Alarm speed+123456+space +speed limit Overspeed alarm speed scope: 20-150km/h
IMEI Checking imei+123456
Sleep Mode sleep123456 time If device keep stationary more than 5 minutes the device will enter into sleep mode automatically, SMS commands and call can wake up it
sleep123456 shock If device keep stationary more than 5 minutes the device will enter into sleep mode automatically, vibration, SMS commands and call can wake up it
sleep123456 off Cancel sleep mode
Vibrate Alarm vibx, y x=1-3 (1: SMS alarm, 2: Call alarm, 3: SMS first then Call); y=1-9,1 is the most sensitive
vibcall+123456 Vibrate call alarm set ok (If device keep stationary more than 5 minutes the device will enter into sleep mode automatically, vibration, SMS commands and call can wake up it)
vibalm+123456 Vibrate SMS alarm set ok (If device keep stationary more than 5 minutes the device will enter into sleep mode automatically, vibration, SMS commands and call can wake up it)
Tow Alarm towA,B A: 1-4, 1: SMS alarm, 2: Call alarm, 3: SMS+Call, 4: Platform alarm; B: Distance (500-10000m)

Any Questions?

E-mail: support@micodus.com
Skype: MiCODUS

Download the APP

Search "MiCODUS" in iOS APP store or Google Play Store, or just scan the QR code as below to download MiCODUS APP:

www.apple.com
play.google.com

Copyright ©2022 MiCODUS | All Rights Reserved

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download MICODUS MV720 - GPS tracker Manual

Advertisement

Need help?

Need help?

Do you have a question about the MV720 and is the answer not in the manual?

Questions and answers

Related Manuals for MICODUS MV720

Save Article as PDF

Table of Contents