Settings; Setting The Tear Position - TallyGenicom SprintPro 2265+ Quick Start Manual

Settings

Settings
This section describes how to set the tear position, the first printing line, the print head gap as
well as the font selection and the character density.
➤
Setting the tear
If the tear position of the paper is not aligned with the tear edge of the top cover of the printer,
position
you can adjust it.
Adjust Paperway
Online
Menu Char
1 2 3 4
Setup
TOF
Online
Head Tear
1 2 3 4
Setup
TearAdj= 0/72" *
Online
Set < > Exit
1 2 3 4
Setup
The correction made – a maximum of approx. 2.5 cm (1") in each direction – will be retained
after switching the printer off.
22
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key. The printer performs a form feed.
Press the < (2) or > (3) key to move the perforation to the desired position. Confirm
the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the initial
status.
Quick start guide