Settings; Setting The Tear Position - TallyGenicom 7265 Operator's Manual

Settings

Settings
This section describes how to set the tear position, the first printing line, the print head gap as
well as the font selection and the character density.
Setting the tear
If the tear position of the paper is not aligned with the tear edge of the top cover of the printer,
position you can adjust it.
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
TOF
Head Tear Online
1 2 3 4
Setup
TearAdj= 00/72"*
Set < > Exit Online
1 2 3 4
Setup
The correction made – a maximum of approx. 2.5 cm (1") in each direction – will be retained
after switching the printer off.
20
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key. The printer performs a form feed.
Press the < (2) or > (3) key to move the perforation to the desired position.
Confirm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the
initial status.
Quick start-up