Table of Contents
Advertisement
Click the Call forwarding tab to see the Call Forwarding parameters.
In order to enable toll bypass of incoming PSTN calls, change the
Phone Line to Skype™ settings as follows:
When you call into your telephone line you will hear a beep. Enter the
pin code followed by the * button and then enter the Skype™ speed
dial (e.g. 50) or the SkypeOut™ telephone number (e.g. 00 + country
code + telephone number) followed by the * button.
In order to perform toll bypass on an incoming Skype™ call, enable
Toll Bypass in the Skype™ to Phone Line section. When you Skype™
into the USB Skype™ Phone Adapter, you will hear a beep. Enter the
pin code followed by the * button and then enter the telephone number
you want to dial on the PSTN line followed by the * key.
21
Skype™ Voicemail
With the USB Skype™ Phone Adapter active, the attached telephone
handset can be used to check for, and listen to your Skype™ voicemail.
When you have a new Skype™ voicemail that you have not listened
to, you will hear an intermittent beep in the Skype™ dial tone. If you
have no new voicemail (i.e. either no voicemail or voicemail that you
have already listened to), the standard Skype™ dial tone will be heard.
You can access your voice mail only when there is no call in progress.
In order to access your voicemail:
1. Pick up the attached telephone handset
2. Press ## to get Skype™ dial tone (only in PSTN mode)
3. If a new Skype™ voice message exists the Skype™ dial tone
will have an intermittent beep
4. Press * to access voice mail mode
5. Once in voice mail mode the first message is played
automatically
6. At the end of each message a trailing "beep" is played
7. At the end of the last message a trailing "beep-beep-beep" is
played
8. During the playing of current message and within 5 seconds
following the end of message the you can press the 1, 2, 3, 9
in order to perform the following actions:
User Action
Repeat current message
Delete current message, move to next
Keep current message, move to next
Delete all messages
9. If you don't enter any valid key within 5 sec after message
has ended, the system will behave as if you pressed "3"
To exit voicemail mode press "##" or place the attached telephone in
the handset (i.e. on hook). Alternatively, pressing "#1" will also exit
Key
1
2
3
9
22
Advertisement
Table of Contents
