Advertisement
28.
With Rafter Section correctly aligned, secure rafters to walls
using 2 - 90° Metal Brackets per side. Attach each brackets with
4 - 1 1/4" Screws. Screw into Wall Extension Framing at the rear
and Wall Panel top framing at the front. Complete both sides.
29.
With outside rafters properly secured, attach remaining interior rafters using
1 - 3" Screw per rafter end. Screw into rafters from inside of Header on an angle at
front of shed, and from inside of Extender Wall Framing at rear of shed.
30.
There are 4 different plywood roof panel sizes required to
complete Start with an Outside Large Plywood Panel first.
Position so Plywood overhangs outside rafter by 2". In the front,
plywood will be recessed 1/8" back from rafter end. With panel
positioned correctly, attach to rafters with 9 - 1 1/4" Screws per
rafter.
Hardware (Steps 30 - 33)
S2 - 1 1/4" Screws x 45 total
Toll Free 1-888-658-1658
2" overhang
www.outdoorlivingtoday.com
3F - Large Roof Panels - Outside
3H - Small Roof Panels - Outside
Page 20
90° Metal Brackets
Hardware
Y2 - 90° Metal Bracket x 4 total
S2 - 1 1/4" Screws x 16 total
S4 - 3" Screws
Recessed 1/8" back
from rafter end.
Parts (Steps 30 - 33)
(5/8" x 48"d x 50"w) x 2
3G - Large Roof Panel - Center
(5/8" x 48"d x 45 1/2"w) x 1
(5/8" x 5 3/4"d x 50"w) x 2
3I - Small Roof Panel - Center
(5/8" x 5 3/4"d x 45 1/2"w ) x 1
sales@outdoorlivingtoday.com
Hardware
x 14 total
Advertisement
