Verify Anti-Tip Bracket Is Installed And Engaged - Whirlpool WGG745S0FH Installation Instructions Manual

3. Use a 15/16" (23.8 mm) combination wrench and an
adjustable wrench to attach the flexible connector to the
adapters. Check that connector is not kinked.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas pressure regulator too tight.
Making the connections too tight may crack the regulator
and cause a gas leak. Do not allow the regulator to turn
when tightening the fittings.
H
G
F
A.Gas pressure regulator
B.Use pipe-joint compound.
C. Adapter (must have
1/2" (12.7 mm) male pipe
thread)
D. Flexible connector
4. Gas supply pipe must be located within the shaded area as
shown in the "Cabinet Dimensions" illustration in "Location
Requirements" section.
A
Adaptor
B
C
A. Gas pressure regulator
B. Adapter
C. Flexible connector
D. Manual shutoff valve
Complete connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
A
B
C
D
E
E. Manual gas shutoff valve
F. 1/2" or 3/4" (12.7 mm or 19.0
mm) gas pipe
G. Use pipe-joint compound.
H. Adapter
D
B
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
3. Remove cooktop burner caps and grates from parts
package. Align recess in burner caps with pins in burner
base. Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light. Place burner grates over burners and caps.
4. Plug into a grounded 3 prong outlet.
Verify Anti-Tip Bracket Is Installed and
Engaged
1. Place the outside of your foot against the bottom front of the
oven door to keep the unit from moving, and grasp the lower
right or left side of the control panel as shown.
NOTE: If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown in
the illustration.
2. Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
9