Air Intake Oil Cooler Fan Cs104 L1/R1 Compressor; Observe The Tightening Torques - Ingersoll-Rand GHH RAND SILU CS104 Mounting Instructions

3.4.5

Air intake oil cooler fan CS104 L1/R1 compressor

For compressors and units with an integrated oil cooler (compressor types CS104 L1/R1), the rain cap
for the air intake of the oil cooler fan must be installed in the vehicle frame so that it is outside the spray
areas and the cleanest, coldest possible air is sucked in.
NOTICE
INCORRECT INSTALLATION POSITION OF THE AIR INTAKE OIL COOLER FAN!
If the fresh air supply to the oil cooler fan is restricted, is located in the area of warm air or dirt gets
into the oil cooler, temperature damage to the compressor could occur.
‣
Ensure sufficient fresh air supply.
‣
Do not operate the compressor without an air intake oil cooler fan.
‣
The air intake must not be located in the area of warm air (e.g. exhaust air from the engine).
NOTE
To ensure sufficient air throughput, the nominal width (NW 125) of the connection line for the oil cool‑
er fan may not be reduced. The connection line should be kept as short as possible and installed in a
straight line.
3.5

Observe the tightening torques

The tightening torques are specified in the following chapters.
WARNING
INCORRECT TIGHTENING TORQUE!
An incorrect tightening torque can endanger the secure attachment of the compressor, or result in
damage to components due to excess tightening torques.
‣
The specified tightening torques must be observed.
47757787 A
Installation guidelines
23