Setting The Time Automatically; Setting The Time Manually - Grundig M 2200 Manual

SETTINGS
Setting­and­storing­FM­radio­
stations­automatically
The device searches for up to 40 stations with
strong reception and stores them automatically.
After the search has finished, you will hear the
station stored at preset 01.
1 Activate the station search by pressing
»PROG« until the frequency display changes
to rapid run-through.
– D isplay: »AUTO SCAN«.
Setting­and­storing­FM­radio­­
stations­manually
1
Set the radio station by briefly pressing »
or » « repeatedly on the remote control.
4
– D isplay: the frequency changes in steps of
50 kHz;
or
press and hold down »
remote control until the frequency changes to
rapid run-through.
2 Save a radio station as a preset by pressing
»PROG«, selecting the preset with »
» « on the remote control and then press
6
»PROG« to save.
3 To search and save more radio stations, repeat
steps 1 to 2.
Setting­the­time­automatically
The time is updated automatically if a DAB or
RDS radio station transmits a time signal.
Note:
The time must be reset after a power failure
7
or after disconnecting from the mains.
1­Select the DAB input source by pressing
»SOURCE« on the device or »FM/DAB« on
the remote control.
2 Select a DAB radio station by pressing »
» « on the device »
control.
14­ ENGLISH
­ - --------------------------------------------------------------------------------------------------------------------------------------
3
« or » « on the
3 4
5
« or » « on the remote
5 6
3 Press »INFO« on the remote control to switch
to the time display for the DAB radio station
and confirm the time with »
– D isplay: »CT SYNC«, the time is adopted.
Note:
Some RDS stations (FM radio stations) trans-
7
mit an RDS time signal. If the selected RDS
station transmits time information, the time
can be updated automatically.
In FM tuner mode, press »RDS« repeat-
edly until the time is displayed. If »DATE/
CLOCK« is displayed, the time signal has
not yet been received. Please wait until the
time is displayed.
«
If the correct time is displayed, press and
hold » « to confirm it.
Setting­the­time­manually
The time can also be set manually.
1 Switch off the hi-fi by pressing »
2 To set the time in standby mode, press and
¥
hold » « for about 2 seconds.
– D isplay: »CLOCK SET« and then
»CLOCK 24 HR«.
« or
2 Select the hour format (12 or 24 hours) by
pressing »VOLUME« on the device or by
pressing »
5
and confirm with »
– T he hours flash.
3 Set the hours by pressing »VOLUME« on the
device or by pressing »
mote control and confirm with »
– T he minutes flash.
4 Set the minutes by pressing »VOLUME« on the
device or by pressing »
mote control and confirm with »
– Display: the current time.
« or
e II«.
8 «.
« or » « on the remote control
6
¥
«.
« or »
5 6
¥
«.
« or »
5 6
¥
«.
« on the re-
« on the re-