Installation; Unpacking & Inspection; What's Included; Preparation For Installation - Emerson SolaHD S4K2UC Series User Manual

2.0 Installation

2.1 Unpacking & Inspection
Unpack the UPS and conduct the following checks:
Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and your local dealer
•
or SolaHD representative immediately.
Check the accessories against the delivery list. If there are any discrepancies, contact your local dealer or SolaHD
•
representative immediately.

2.2 What's Included

Compact disk containing: MultiLink, con guration program and user manual
•
One, 6-1/2 ft. (2 m) long USB cable
•
Mounting hardware, including screws and handles
•
Two plastic tower stand sets (four pieces total)
•
Terminal block communication terminals
•
Warnings, Safety Instructions booklet and WEEE recycling sheet (ISO 14001 compliance)
•
NOTE: The S4K2UC external battery cabinet shipping package includes one battery cabinet, two spacers for tower
con guration and one dc power cable.

2.3 Preparation for Installation

2.3.1 Installation Environment

Install the UPS indoors in a controlled environment, where it cannot be accidentally turned o . The installation envi-
•
ronment should meet the speci cations listed in "9.0 Speci cations".
Place the UPS in an area of unrestricted air ow around the unit, away from water, ammable liquids, gases, corro-
•
sives, and conductive contaminants. Avoid direct sunlight.
NOTE: Operating the UPS in temperatures above 25°C (77°F) reduces battery life.

2.3.2 Installation Clearances

Maintain at least 4 inches (100 mm) clearance in the front and rear of the UPS. Do not obstruct the air inlets on the front
panel and rear panel of the UPS; blocking the air inlets reduces ventilation and heat dissipation, shortening the service
life of the unit.
S4K2UC SERIES USER MANUAL | 15